Recently Added Photos

Installed Quick Prime switch
0
Arctic Cat tether switch installed in rubber plug
0
Connector end view
0
Assembled LED connector
0
2nd design LED connector
0
Connector end view
0
Assembled LED connector
0
2nd design LED connector
0
Detailed view of the shut off valve.
0
Typical separator drain relocation modifcation view
0
Valve flow direction view
0
Valve positioning
0
Cutting the rear tube to length
0
Shut off valve located on the rear port
0
Harness routing view
0
Over head view of the valve.
0
Installed valve on Yamaha/MPI turbo Vipers.
0
Shut off valve location in vent hole
0
Close up view of the lengthen MCX breather tube.
0
View of installed shut off valve. NOTE FOR USE WITH MCX VIPER'S WITH THE STOCK SEPARATOR TANK DRAIN
0
Intalled MCX breather tube with ROV shut off valve in place. (FOR MCX VIPERS WITH STOCK SEPARATOR TANK DRAIN)
0
MCX breather tube W/O ROV installed (WITH STOCK SEPARTOR TANK DRAIN)
0
Complete Standard M1100T/M9000 Roll Over Valve kit
0
Complete Premium M1100T/M9000 Roll Over Valve kit
0
Over head view of the shut off valve
0
View of hoses and valve in place
0
Dan added this 90 degree hose to mate with his cold air intake.
0
Second view of adapter.
0
Original adapter to mate with cold air intake.
0
Underhood view of Dan's cold air intake tube.
0
Latter sytle MCX air/oil separator tank
0
Tether and Quick-prime switch
0
Installed tether switch and Quick-prime switch
0
Complete XF7000/Viper Roll-Over Valve kit
0
Installed Quick-prime switch underneeth view
0
Testing for underhood clearance at the breather tube.
0
Installed shut off valve for installations with a stock separator drain
0
Valve and tubing assembly (stock separator drain)
0
Main harness and snowmobile harness
0
Upper harness view
0
Installed upper harness view
0
Upper harness plug/play connectors
0
Close up view of the 4 wire hood release connection
0
Assembled upper harness.
0
Close up view for the LED wires
0
LED wiring connection to the flat 4 wire connector
0
Installed Red flashing LED light
0
Installing the LED
0
Modified forward breather pipe (Stock Viper/7000 separator drain
0
Tubing cutter and breather pipe (Stock Viper/7000 separator drain)
0
Forward breather tube cutting. (Stock Viper/7000 separator drain)
0
Cutting the breather hose to length. (Stock Viper/7000 separator drain)
0
Removing the forward breather tube on stock Viper/7000 separator drain
0
ROVCM mounting view.
0
Roll-Over Valve (ROV) ground wire view.
0
ROVCM harness routing view.
0
Main ROV harness routing view.
0
Fuel tank vent hose clearance view.
0
ROV harness routing view.
0
Drilling a 1/2" hole using a rotobroch cutting tool.
0
1 2 3
1 - 60 of 137 Photos