Installation on a FX/Nytro

2nd design LED connector

« Back to Album Photo 11 of 13 Previous | Next
2nd design LED connector
Starting 2017, some Nytro ROV kits will use a 2nd design connector. To install the LED light, first slide the wire/terminals through the previously drilled 5/16" hole in the cowling. Then insert the terminals into the connector. Note: the terminals are directional and install them as shown in the picture. Install the Red wire in cavity "A" , Back to cavity "B"
Posted by ★ Owner on February 13, 2017 Full Size| Slideshow

Post a Comment

Oops!

Oops, you forgot something.

Oops!

The words you entered did not match the given text. Please try again.

0 Comments