Installation on a SR/Viper and XF7000

Complete XF7000/Viper Roll-Over Valve kit
0
Locating and drilling the pilot hole for the tether switch
0
Drilling a 1/2" hole using a rotobroch cutting tool.
0
Installed Quick-prime switch underneeth view
0
Installed tether switch and Quick-prime switch
0
Tether and Quick-prime switch
0
Fuel tank vent hose clearance view.
0
ROV harness routing view.
0
Main ROV harness routing view.
0
ROVCM harness routing view.
0
Roll-Over Valve (ROV) ground wire view.
0
ROVCM mounting view.
0
Detailed view of the shut off valve.
0
Removing the forward breather tube on stock Viper/7000 separator drain
0
Cutting the breather hose to length. (Stock Viper/7000 separator drain)
0
Forward breather tube cutting. (Stock Viper/7000 separator drain)
0
Tubing cutter and breather pipe (Stock Viper/7000 separator drain)
0
Modified forward breather pipe (Stock Viper/7000 separator drain
0
Valve and tubing assembly (stock separator drain)
0
Installed shut off valve for installations with a stock separator drain
0
Installing the LED
0
Installed Red flashing LED light
0
LED wiring connection to the flat 4 wire connector
0
Close up view for the LED wires
0
Assembled upper harness.
0
Close up view of the 4 wire hood release connection
0
Upper harness plug/play connectors
0
Installed upper harness view
0
Upper harness view
0
Main harness and snowmobile harness
0
Testing for underhood clearance at the breather tube.
0
 
1 - 31 of 31 Photos
Rss_feed